Iron-On Repair Pockets, 2 pc

Usage Instructions:

Always test to be sure temperature and timing are appropriate for fabric.

1. Heat dry iron for 5 minutes on cotton setting.
2. Cut off bottom of worn pocket 1-1/4 inch below where pocket is stitched into side seam. Mark 1 inch up from cut edge.
3. Working on a firm, protected surface, preheat old pocket with iron.
4. Insert cut end of old pocket into repair pocket, aligning top of repair pocket with 1 inch mark. Pleat old pocket to fit if necessary.
5. Press iron-on strip firmly for 40 to 45 seconds; do not move iron. Finish by pressing around all edges.
6. Allow pocket to cool and check bond. Press again if necessary. Can be used for back pockets too!