Instant Vinyl, Transparent Adhesive, 1 fl. oz.

Usage Instructions:

Instructions: Before first use, unscrew entire cap and puncture tube seal with top of overcap. Replace cap. 1. To use, remove overcap only. Gently squeeze tube from bottom. Lay tube on paper to catch drips when cap is off. 2. Clean the surface where adhesive will be applied. 3. For small cuts or tears apply a small amount to edges and spread evenly using nozzle tip or a toothpick. 4. For larger cuts or tears, insert a scrap piece of vinyl under the cut. Apply to inserted scrap, edges and sides of cut. Press down and smooth out vinyl. Place tape over mended area to hold in place and allow to dry. 5. Check bond after 45 minutes, allow 24 hours to fully dry. 6. Keep tube tightly capped when not in use. Hint – Prior to use apply a small amount of petroleum jelly to the nozzle to prevent glue buildup. CONTAINS: methyl ethyl ketone and acetone. Keep away from all sources of ignition & open flame. Use in well-ventilated area. Avoid contact & inhalation. If swallowed, seek medical attention immediately. If skin contact, wash thoroughly. If in eyes, rinse with water for 15 minutes. If inhaled & feeling unwell, move to fresh air. If symptoms persist, seek medical attention. KEEP OUT OF REACH OF CHILDREN. Glue made in USA, tube made in Pakistan